Epson TM-H6000III Manual Del Usuario página 19

Endorsement Printing
See illustration J.
If your printer has the optional endorsement printing mechanism, install the
endorsement ribbon following the steps below:
Use genuine Epson ERC-41 ribbon cassettes.
Note:
Be sure to turn on the power before installing a ribbon cassette.
1. Turn the ribbon cassette knob. Then open the unit cover.
2. Inside the printer, push the levers backward to open the unit.
Note:
Do not open the unit during printing.
3. Insert the ribbon and turn the knob again to seat the ribbon; then close the
printer.
Cleaning the Slip Image Scanner
See illustration K.
The glass part of the scanner (indicated by the arrows in the illustration) may
become dirty due to ink or paper dust, which can decrease the image quality. To
avoid this, clean the glass part every 12 months.
1. Open the unit cover.
2. Inside the printer, push the levers backward to open the unit.
3. Wipe the glass gently with a soft, dry cloth.
Note:
When cleaning the scanner glass, do not use any liquid, such as detergent, benzine, or
water.
Liquids can reach the back of the scanner glass and cause it to become dirty. If the scanner
glass has foreign matter that is hard to remove, such as oil or grease, you can wet a cloth a
little with alcohol and wipe the scanner glass, but never put any liquid directly on the
scanner glass.
Card Image Scanning
1. Wait until the ID LED flashes. Then insert the card face up into the card
entrance as far as it will go. See illustration L.
2. The printer will detect the card and start drawing it in. When the printer
starts drawing it in, let go of the card immediately. When the printer ejects the
card and the ID LED starts flashing again, remove the card by pulling it
straight out; do not pull it at an angle.
TM-H6000III with Image Scanner (Photo-ID Model) 9
English