GYS AUTOPULSE 220-M1 Manual Del Usuario página 32

Process parameters: corresponds to the process parameter setting window:
• MIG-MAG (GMAW): Material/gas pair (Synergic welding parameters), wire diameter,
welding process (Manual, Dynamic STD, etc.), trigger mode.
3
Energy: configuration of the energy mode, developed for welding with energy control
supervised by a DMOS (see chapter «ENERGY MODE»).
: corresponds to the program recall modes window:
4
• JOB: create, save, delete and recall JOB.
• QUICKLOAD: JOB recall using the trigger when not welding.
SEMI-AUTOMATIC WELDING (MODE MIG / MAG) - GMAW
THE SETTINGS OF THE MIG / MAG PROCESS
Settings Designation
Torque
material/gas
Wire diameter
Welding process
ModulArc
(Arc Module)
Trigger behaviour
Tack welding mode
Settings
Energie
32
AUTOPULSE 220
Adjustable settings Manual
- Fe Ar CO2 18%
- Al Mg 5 Ar 100%
- HARDFACE Metal
- etc
Ø 0.6 > Ø 1.2 mm
- Manual
- Dynamic STD
- Pulse
- Cold Pulse
OFF - ON
2T, 4T
Spot, Delay
Thickness
Speed
Current
Hold
Thermal coeff.
Dynamic STD
Pulse
(Standard)
Choice of the material to be welded.
Synergic welding parameters
Choice of wire diameter
Enables or not the modulation of the welding
current (appearance of a TIG weld bead)
Choice of trigger welding management mode.
Choice of scoring mode
Choice of the main parameter to be displayed
(Thickness of the part to be welded, wire
speed, average welding current).
See chapter «ENERGY MODE» on pages
following.
EN
Recommendations