Publicidad
Idiomas disponibles
Idiomas disponibles
JOB MODE
This mode allows you to create, save, recall and delete JOBs.
QUICK LOAD – Recall of the JOBs using the trigger when not welding.
The Quick Load is a JOB recall mode (20 max) excluding welding and possible only in MIG-MAG processes.
From a Quickload list of previously created JOBs, JOBs are recalled by pulling the trigger briefly. All trigger modes (2T/4T) and welding modes (SPOT/
STD/PLS) are supported.
OPTIONAL TORCHES
• Push-Pull Torch (4m : ref. 046283) :
The Push-Pull torch is mounted on the connector (I - 13). This type of torch allows the use of AlSi wire even in Ø 0.8 mm with a 4 m long torch.
This torch can be used in all modes.
The detection of the Push-Pull torch is done by simply pulling the trigger.
If a potentiometer Push-Pull lamp is used, the setting on the interface is used to set the maximum value of the adjustment range.
The potentiometer then allows to vary between 50% and 100% of this value.
Connection diagram for Push Pull torch
with potentiometer (10 KΩ)
1 - Choice of setting (speed or arc height)
2 - Orange LED (arc height)
3 - Green LED (speed)
4 - Increment (speed or arc according to button 2)
5 - Decrement (speed or arc according to button 2)
PRODUCT SETTINGS
INFORMATION
This menu provides access to version numbers of the boards and software.
38
AUTOPULSE 220
+ supply (4)
3
2
1
7
6
5
4
10
9
8
logic gnd (5)
(53068)
1
2
5
+supply (10)
(1)
cursor (2)
M
analog gnd (3)
(8)
3
4
EN
+
-
Publicidad
