Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Instructions
STEP 1: STOP! Read operator's
manual before operating this
machine. Failure to read operation
and warning instructions may result
in personal injury or property
damage. Connect water supply
hose to inlet connector and turn
water on.
Coupler
Collar
STEP 4: Pull the spring-loaded
collar of the wand coupler collar
back to insert your choice of
pressure nozzle. CAUTION: Never
replace nozzles without
engaging the safety latch on the
spray gun trigger.
ATTENTION: Ne jamais
remplacer les buses sans
d'abord mettre le dispositif de
sécurité sur la détente du
pistolet pulvérisateur.
VHP 2-1500 / 3-2000 Operator's Manual 8.913-949.0 - AU
STEP 2: Turn all switches off.
Remove and position LP tank as far
from machine as supply hose will
allow.
STEP 5: Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
Turn Pump/
Burner
Switch Off
STEP 3: Before installing nozzle,
Pull trigger on spray gun allowing
water to flow until all air has been
discharged from the system. Check
for water leaks and tighten as
needed.
Grip spray gun variable pressure
wand securely. Then turn the
variable pressure control handle
counterclockwise to flush any
debris out of soap nozzle.
Brass Soap
High
Pressure
Nozzle
Variable Pressure
Control Handle
.
STEP 6: Selection of high or low
pressure is accompanied by turning
the handle.
NOTE: High pressure nozzle
must be inserted at end of wand
to obtain high pressure. To apply
soap read operator's manual.
Operations
Nozzle
Variable Pressure
Wand (VP)
Trigger
15
Publicidad
