GreenWorks Pro ULTRAPOWER CS60L03 Manual Del Operador página 110

EN
2. Line up the recesses of the side discharge chute (11)
below the pivot (20).
3. Close the side discharge door (19).
7.7 SET THE CUTTING HEIGHT
The machine can be set to different cutting height.
1. Pull the height adjustment lever (8) rearward to increase
the cutting height.
2. Pull the height adjustment lever forward to decrease the
cutting height.
7.8 INSTALL THE BATTERY PACK
22
28
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
8
9
21
WARNING
English
The machine has an automatic switch function that lets the
other battery work when the first cannot operate.
1. Open the battery door (9).
2. Align the ribs on the battery pack (22) with the grooves in
the battery compartment.
3. Push the battery pack (22) into the battery compartment
until the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.
The motor starts only when you put in the safety key (21).
7.9 REMOVE THE BATTERY PACK
1. Open the battery door (9).
2. Remove the safety key (21).
3. Push and hold the battery release button (28).
4. Remove the battery pack (22) from the machine.
8 OPERATION
Wear eye protection during operation.
8.1 START THE MACHINE
1
23
2
1. Make sure safety key is inserted into slot.
2. Push and hold the start button (1).
3. While you hold the start button (1), grab the start handles
(2) in the direction of the handle bar.
4. Once the machine has started, you can release the start
button (1).
5. Press the Turbo button (29) to speed up to 3,200 RPM.
Battery capacity indicator (23)
Lights Capacity
10
NOTE
NOTE
WARNING
TURBO
TURBO
2
29