GreenWorks Pro ULTRAPOWER CS60L03 Manual Del Operador página 63

5. Push the spool cover until it clicks into position.
10.4 INSTALL THE CUTTING LINE
Do not put more than 13 feet of cutting line in at a time.
1. Remove the remaining cutting line on the spool.
2. Line up the slots on the spool cap with the slots on the
trimmer head.
Spool
cover
3. Put the cutting line through the hole. Push the cutting line
until it exits the opposite hole.
NOTE
Bump
head
English
4. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
5. Turn the spool cap counterclockwise to wind the cutting
line into the trimmer head. Keep approximately 5 in of
cutting line on each side of the trimmer head.
10.5 REPLACE THE BUMP KNOB
1. Push the tabs on the sides of the trimmer head at the same
time.
2. Pull and remove the spool cover.
3. Remove the spool.
4. Hold the bump knob and firmly pull it out.
11
Hole
EN