GreenWorks Pro ULTRAPOWER CS60L03 Manual Del Operador página 55

1 Description......................................... 4
1.1 Purpose.............................................................. 4
1.2 Overview........................................................... 4
1.3 Packing list........................................................ 4
2 Important safety instructions...........4
3 Symbols on the machine................... 5
4 Risk levels...........................................6
5 Service................................................ 6
6 Environmentally safe battery
disposal............................................... 6
7 Proposition 65.................................... 6
8 Installation......................................... 7
8.1 Unpack the machine.......................................... 7
8.2 Attach the guard.................................................7
8.3 Attach the edge guide........................................ 7
8.4 Assemble the shaft.............................................7
8.5 Attach the auxiliary handle................................8
8.6 Install the battery pack.......................................8
8.7 Remove the battery pack................................... 8
9 Operation........................................... 8
English
9.1 Start the machine............................................... 8
9.2 Stop the machine............................................... 8
9.3 Adjust the length of the cutting line.................. 9
9.4 Line cut-off blade.............................................. 9
9.5 Adjust the cutting diameter................................9
9.6 Operation tips.................................................... 9
9.7 Cutting tips...................................................... 10
10 Maintenance.....................................10
10.1 General information.........................................10
10.2 Clean the machine........................................... 10
10.3 Remove excess line......................................... 10
10.4 Install the cutting line...................................... 11
10.5 Replace the bump knob....................................11
11 Transportation and storage............ 12
11.1 Move the machine........................................... 12
11.2 Store the machine............................................ 12
12 Troubleshooting............................... 12
13 Technical data.................................. 13
14 Limited warranty............................ 13
15 Replacement parts...........................14
3
EN