Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
A
Amperes
Hz
Hertz
W
Watts
min
minutes
Alternating
Current
Position of date code
The Date Code, which also includes the year of manufacture, is
printed into the housing.
Example:
2020 XX JN
Year of manufacturing
Additional safety instructions for batteries
and chargers
Batteries
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not store in locations where the temperature may
u
exceed 40 °C.
Charge only at ambient temperatures between 10 °C and
u
40 °C.
Charge only using the charger provided with the tool.
u
When disposing of batteries, follow the instructions given
u
in the section "Protecting the environment".
Chargers
Use your STANLEY charger only to charge the battery in
u
the tool with which it was supplied. Other batteries could
burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
u
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
This charger can be used by children aged from 8
u
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the charger in a safe way
and understand the hazards involved.
Children shall not play with the charger. Cleaning
u
and user maintenance shall not be made by children
without supervision.
32
(Original instructions)
n
No-Load Speed
0
Class II
Construction
Earthing Terminal
Safety Alert
Symbol
Revolutions or
/min.
Reciprocation per
minute
The charger is intended for indoor use only.
Read the instruction manual before use.
Do not attempt to charge damaged batteries.
Electrical safety
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on
the rating plate. Never attempt to replace the
charger unit with a regular mains plug.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised STANLEY Service Centre
in order to avoid a hazard.
Warning! Never attempt to replace the charger unit with
a regular mains plug.
Features
This appliance includes some or all of the following features.
1. Lock off switch
2. Trigger switch
3. Side handle
4. Spindle lock
5. Guard
6. Battery
7. Two pin spanner
Use
Warning! Let the tool work at its own pace. Do not overload.
Be prepared for a stream of sparks when the grinding or
u
cutting disc touches the workpiece.
Always position the tool in such a way that the guard
u
provides optimum protection from the grinding or
cutting disc.
Charging the battery (Fig. A)
The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that were
easily done before. The battery may become warm while
charging; this is normal and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging
temperature: approx. 24 °C.
Note: The charger will not charge a battery if the cell
temperature is below approximately 10 °C or above 40 °C.
The battery should be left in the charger and the
charger will begin to charge automatically when the cell
temperature warms up or cools down.
Publicidad
