Publicidad
Idiomas disponibles
Idiomas disponibles
FOCUS mODE
You can select a focus mode according to the
angle that you adjusted for camera recording.
- AF : This will monitor the screen continuously
to focus automatically. If you adjust the focus
manually, that will operate the same as in
<mF>. This will also restore focus after the
operation of pan/tile/zoom.
- ONEAF : Restores focus after the operation
of pan/tile/zoom, and operates the same as
in <mF> unless the operation of pan/tile/
zoom is executed.
- MF : You can adjust the focus manually.
M
While you are working on the following objects, <AF> may not work properly.
If this is the case, use <MF> instead.
- Very bright object, or dominant object in a dark scene
- Object against the rear side of a moist or dirty glass
- A scene where nearby and distant objects co-exist
- White wall or single-colored object
- Venetian blinds and other horizontally striped objects
ZOOm SPEED
You can adjust the zoom operation speed.
DISPLAy ZOOm
You can set to display the zoom status on the screen.
It will disappear in about 3 seconds if the zoom factor has no further change.
DISPLAy P/T
You can set to display the operation status of pan/tilt when it is active.
It will disappear in about 3 seconds if the pan/tilt position has no further change.
However, the allowable error is ± 2°.
DIGITAL ZOOm
You can set the maximum allowable digital zoom ratio.
Digital Zoom will start operation after it is zoomed in to the maximum optical ratio of
x34. If you set DIGITAL ZOOM to x16, you can take a shot at up to x544 (34x16).
DETAIL
Used to adjust the vertical and horizontal distinction, respectively.
DAY/NIGHT
WHITE BAL
FOCUS MODE
ZOOM SPEED
DISPLAY ZOOM
DISPLAY P/T
DIGITAL ZOOM
DETAIL
V-SYNC
English _1
AUTO
ONEAF
[2]
OFF
OFF
X16
[2]
INT
Publicidad
