Cleaning The Motor Protection Filter - Bosch BSG813 Serie Manual De Instrucciones

Cleaning the motor protection filter

The motor protection filter should be cleaned reg-
ularly by knocking out the dirt and rinsing.
Open the dust bag compartment lid.
Pull out the motor protection filter in the direc-
tion of the arrow.
Clean the motor protection filter by tapping it.
If it is very dirty, the motor protection filter
should be rinsed.
The filter must then be left to dry for at least 24
hours.
After cleaning, insert the motor protection filter
into the appliance as far as it will go and close
the dust bag compartment lid.
You can obtain a new motor protection filter on
request as a spare part from the after-sales service.
Replacing the HEPA / Activated carbon
cartridge
Press the exhaust grille latch in the direction of
the arrow to unlatch the exhaust grille and open
it.
Press the filter frame latch in the direction of the
arrow to unlatch the filter frame and remove it
.
15