Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Steering shaft
Hole
Washers
Bolts
Model cover plate
Steering wheel
Steering column
Steering shaft
1. Install the steering shaft into the coupler, rotating as
needed to align hole in shaft with bolt hole in coupler.
2. Install two bolts and tighten securely.
Torque bolts to the value as shown.
Bolt holes
13.2ft.lbs
Bolt
Washer
Slot
NOTE
English
3. Install the steering column. Note the tabs on the bottom
of the steering column that fit into the holes in the
opening and make sure steering column is securely
seated.
4. Make sure the mower's wheel is pointed straight ahead,
then install the steering wheel over the steering column
with force.
5. Install the bolt and washer; tighten securely.
6. Install the steering wheel cover plate.
18.4ft.lbs
7.4
INSTALL THE ACCESSORIES
1. Mulch cover
7.4.1
INSTALL THE MULCH COVER
Bolt
Mulch cover
Nut
Washer
Bracket
Bolt
The mower is configured for side discharge when shipped. If
mulching is desired:
1. Place the mulch cover on the tab on the mower housing.
2. Align the holes in the mulch cover and the holes in the
mower housing.
3. Install and tighten the bolts, screws, fixation clamps and
bearing ring as shown.
8
OPERATION
Wear eye protection during operation.
8.1
BEFORE OPERATION
8.1.1
ADJUST THE SEAT
Adjust the seat position to ensure you are able to make firm
contact with the accelerator and brake pedals before operating
the mower.
10
Bolt
Nut
Bearing ring
Bracket
Nut
Bolt
WARNING
Publicidad
