Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Moving parts
Risk of crushing
Be careful of moving parts when removing
or inserting the upper part of the dirt recep-
tacle.
1. Secure the device with the parking
brakes.
Illustration C
2. Pull the bow handle up.
The dirt receptacle is unlocked and low-
ered.
3. Pull the dirt receptacle out of the device
by the bow handle.
Illustration D
4. Loosen the clamping straps on the dirt
receptacle.
5. Remove the upper part of the dirt recep-
tacle by the bow handle.
6. Fill the inert liquid water or oil into the dirt
receptacle until the filling level reaches
the mark on the filling level indicator.
7. When fitting the upper part of the dirt re-
ceptacle, make sure that the float ball is
inserted into the corresponding guide.
WARNING
Improper handling when locking the dirt
receptacle
Risk of crushing
Under no circumstances should you hold
your hands between the dirt receptacle and
filter ring or allow them to come close to the
lifting mechanism while locking it.
Lock the dirt receptacle by operating the
bow handle with both hands.
Illustration E
ATTENTION
Static charge of the dirt receptacle
Ignition of dusts
Make sure that the grounding on the chas-
sis is in contact with the dirt receptacle.
8. Fit the dirt receptacle in the reverse se-
quence and lock it with the bow handle.
Check the dirt receptacle filling level
The dirt receptacle must be emptied when
filled up to the mark. The device does not
switch off automatically when the maximum
filling level is exceeded.
1. Check the dirt receptacle filling level reg-
ularly.
2. Make sure that no more than 8 litres of
material are sucked in during vacuum-
ing.
DANGER
Suction of explosive and conductive
metal dust without inert liquid
Explosion hazard, heat generation
Never vacuum explosive and conductive
suction material without inert liquid.
WARNING
Danger from dust that is harmful to your
health
Respiratory sicknesses through inhalation
of dust.
Do not vacuum without correctly installed
filter elements, otherwise a danger to
health occurs from increased fine dust
emission.
Before each use, check that both filter ele-
ments are correctly installed.
ATTENTION
Danger due to fine dust entering
Risk of damage to the suction motor.
Never remove the main filter element when
vacuuming.
ATTENTION
Lack of inert liquid
Damage to the wet separator
Never vacuum without inert liquid when us-
ing the suction hose port on the wet separa-
tor.
Switching on the device
1. Plug the mains plug into the socket.
2. Switch on the device via the suction tur-
bine power switches.
Note
Always switch the suction turbines on and
off one after the other. For the correct func-
tion of the pressure gauge for monitoring
the minimum volume flow, all suction tur-
bines must be switched on.
3. Start the vacuuming process.
English
Operation
23
Publicidad
