MEGABRAS MD-5060x Manual De Uso página 12

3.2. Battery charger
This equipment has an intelligent built-in circuit that controls the battery
charge. In order to charge the battery, follow this procedure:
Verify that the On/Off switch is switched off

Connect the equipment into the mains supply (using the supplied AC

Adapter). The charging indicator (
remain that way until the battery is totally charged. Then the light will
remain green and keep in that way until the equipment is disconnected
of the mains supply.
The following chart summarizes the meaning of LED luminous indications:
Green and red flashing
alternatively
Permanent red
Flashing red
Permanent green
Flashing green
Use only the AC Adapter provided by the manufacturer. The use of any other
AC Adapter may compromise the equipment safety.
The rechargeable battery does not have "memory effect" and there are no
restrictions to start charging it as many times as is needed. However the battery
could be damaged if remains in deep discharge for a while. To avoid this effect,
charge the battery before left the equipment in storage and don't let pass more
than 30 days without recharge, even if the instrument wasn't used (under storage,
the battery loses part of its charge).
Test of the initial condition of the battery when plugging the mains,
during one second.
Battery under charge.
Charging current is less than normal.
The charging process has been successfully finished. Battery OK.
The charging process has finished, nevertheless the battery hasn't
received the complete charge.
13
.
) will turn-on red and will