MEGABRAS MD-5060x Manual De Uso página 20

5.2.3. "Pass / Fail" Test mode
Press key in order to determine the lower insulation limit for type
"Pass / Fail test". Select this value using and keys. Possible
values are 10 MΩ, 100 MΩ, 1 GΩor 10 GΩ.
During a "Pass/ Fail test", the MD5060x will indicate when the insulation
resistance is lower than the programmed limit, with an intermittent beep
and the key LED flashing. The key LED will remain flashing until
the end of tests, or until the measurement of the resistance value is
greater than the programmed limit.
21