MEGABRAS MD-5060x Manual De Uso página 30

9.2. Replacing the paper roll – complete
replacement procedure
The following procedure demonstrates how to replace the paper roll by
removing the printer mechanism cover (Requires a Phillips screwdriver).
Precautions
 Perform the following procedure with the equipment POWERED
OFF.
 To eliminate electrical hazards, disconnect the equipment from the
main supply, remove the AC Adapter and disconnect the test
leads.
 Never operate this equipment without the printer mechanism cover
properly placed and fastened with the provided screw.
1 1
To unlock the printer lid, press the
area marked with "PUSH".
4
Remove the printer mechanism
cover.
2
Open the lid, remove the empty roll
and gently pull the leftover paper.
Remove the screw using a phillips
screwdriver.
5
Remove the printer cylinder.
31
3
Pull the printer mechanism cover as
indicated. Be careful to not damage
the snap-fit locks located underneath
the cover.
6
Place the new paper roll with the
paper tip facing down.