Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
Thank you for purchasing a Traxxas Blast high-performance racing boat.
This manual contains the instructions you'll need to operate and maintain
your new Blast. Look over the manual and examine the Blast carefully
before running it. If for some reason you think the Blast is not what you
wanted, then do not continue any further. Your hobby dealer absolutely
cannot accept a Blast for return or exchange after it has been run.
Please read all of the operating instructions and precautions before
attempting to drive your new Blast. These instructions are written with
the assumption that this is your first radio controlled model. Even if
you are an experienced R/C enthusiast, it is important for you to
read and follow the procedures in this manual. Pay special attention
to the mechanical and safety precautions outlined in this manual.
If you have any questions about your new model, call Traxxas'
technical support line at 1-888-TRAXXAS (1-888-872-9927, U.S.
residents only. Outside the U.S., call 972-549-3000). Technical support
is available 7 days a week from 8:30am to 9:00pm central time.
We hope that you will enjoy your Blast for many hours to come.
Required Equipment
To operate the Blast, you will need four (4) AA size batteries for your
transmitter. You will also need a USB-C power adapter and cable for
the included charger.
Where to Run
Select a body of water (must be at least 10 inches deep) that is calm
and free of debris, tree stumps, moss, etc. Also, find a clean, stable
area of shoreline for launching. Be aware that some ponds restrict the
use of model boats. Always choose a launch site which is downwind
so that the wind and waves will drift the boat back to you if it should
ever flip over. Do not run the Blast in salt water.
Preparing to Run
WARNING: FIRE HAZARD!
The included battery chargers are designed for use ONLY
with Traxxas iD® NiMH batteries. Legacy Traxxas High-
Current Connectors are not compatible with the chargers. DO NOT
try to force legacy connectors into the charge connector. DO NOT
attempt to charge LiPo batteries with either charger. DO NOT use
any type of adapter between the charger and the battery. DO NOT
modify the charger or the battery connector.
Charge the Battery Pack (USB-C Charger)
RECOMMENDED POWER ADAPTER AND POWER CABLE
Part No.
Description
2912*
Power adapter, AC, USB-C (45W)
2916*
Power cable, USB-C, 100W (high output)
*Sold separately
1 1
Plug the USB-C cable into a USB-C power
source. The red LED will turn on, indicating
that power is connected.
Power on
6 • TRAXXAS
2 2
Connect a Traxxas iD NiMH
battery to the charger to
begin charging.
3 3
The LED will flash green during charging.
The number of flashes indicates charge
progress.
Battery connected
LED flashes green while charging
CHARGE PROGRESS
1 green flash
2 green flashes
3 green flashes
4 green flashes
Solid green LED
4 4
When the LED is solid green, charging is complete.
Battery connected
LED solid green when charging is complete
LED INDICATION
Solid Red LED
Sample USB-C
AC adapter shown.
Slowly Flashing Green LED
Solid Green LED
Flashing Red LED
Clearing errors
If there is a problem with the battery or the power adapter, the
charger's LED will flash red. See the following error codes and
recommended solutions. If the error code repeats or will not clear,
contact Traxxas Customer Support.
Power on
0 - 25% charged
25% - 50% charged
50% - 75% charged
75% or more charged
100% charged
MEANING
Ready for Charging
Charging (see Charge Progress chart)
Battery Fully Charged
Charger Error (see Charger Error Codes)
Publicidad
