AKG PT 4000 Modo De Empleo página 22

3 Setting Up
3.8.1 Setting Gain Manually
3.8.2 Using
Automatic Gain Mode
4 Operating Notes
4.1 Status Screens and
Setup Menus
4.1.1 LOCK Mode
22
4. You have now the choice of setting the input gain manually (section 3.8.1) or in automatic mode (sec-
tion 3.8.2).
1. To increase the gain value by 1 dB, turn the jog switch briefly to the right.
To decrease the gain value by 1 dB, turn the jog switch briefly to the left. The readout "00" will be fol-
lowed by "Auto" (refer to section 3.8.2).
2. Push the jog switch briefly.
This brings up the following screen:
• If you want to save the new setting, push the jog switch briefly.
The display will show your new gain setting in dB and the "GAIN" label will be flashing.
• If you'd rather not save your setting, turn the jog switch briefly to the left or right. The display will
change to "Save-n".
- Push the jog switch briefly. The display will revert to the original setting, with the "GAIN" label flash-
ing.
3. To set input gain again, repeat steps 1 through 3 above.
4. To return to LOCK mode, push and hold the jog switch for approx. 1.5 seconds.
1. From the Gain menu, hold the jog switch to the right until the display changes as follows:
2. Push the jog switch briefly.
The message "tESt" will start flashing on the display.
3. Talk or sing into the microphone as loud as you can.
The transmitter will automatically set the optimum input gain.
The display indicates the audio level by short lines. The peak level is indicated by a heavier line that
will remain fixed for approx. 2 seconds.
4. Push the jog switch briefly.
This brings up the following screen:
If you want to save the new setting, push the jog switch briefly.
The display will show your new gain setting in dB and the "GAIN" label will be flashing.
• If you'd rather not save your setting, turn the jog switch briefly to the left or right. The display will
change to "Save-n".
- Push the jog switch briefly. The display will revert to the original setting, with the "GAIN" label flash-
ing.
5. To set input gain again, repeat steps 1 through 4 above.
6. To return to LOCK mode, push and hold the jog switch for approx. 1.5 seconds.
In LOCK mode, four status screens are available.
1. To scroll through the status screens in the order shown below, turn the jog switch briefly to the right.