AKG PT 4000 Modo De Empleo página 23

Frequency Screen: Carrier
frequency in MHz, battery
capacity bars. The "MUTE"
label appears if the micro-
phone is muted.
Gain Screen: Input gain in dB.
2. To step through the above screens in reverse order, turn the jog switch briefly to the left.
In SETUP and SILENT modes, the various setup menus described in sections 3.4 through 3.8 come up
in the order shown below:
- Preset Menu
- Frequency Menu
- Battery Screen
- Gain Menu
• To toggle between LOCK mode and SETUP mode, push and hold the jog switch for approx. 1.5 sec-
onds.
In LOCK mode, the "LOCK" label will be shown on the display.
The transmitter is fully functional in SETUP mode, too. Remember, though, that settings may change
if you inadvertently actuate the jog switch.
The transmitter will revert to LOCK mode after about 15 minutes.
• To toggle between LOCK or SETUP mode and SILENT mode:
1. Switch power to the transmitter OFF.
2. Switch power to the transmitter ON by pushing and holding for approx. 1.5 seconds either the
ON/OFF button to enter LOCK mode or the jog switch to enter SILENT mode.
1. To mute the microphone, slide the MUTE switch (4) to the "MUTE" position. The status LED (1) will
change to red.
2. To switch the microphone back ON, slide the MUTE switch (4) to the "ON" position. The status LED
(1) will change to green.
The optional Remote Mute Switch allows you to mute the transmitter if it is mounted in a position where
it is difficult or impossible to use the "on-board" MUTE switch.
1. Plug the cable (1) on the Remote Mute Switch into the REMOTE MUTE jack (2) on the transmitter.
2. Put the Remote Mute Switch in a jacket or shirt pocket or use the belt clip to clamp the Remote Mute
Switch on the belt.
3. To mute the microphone, press the button on the Remote Mute Switch. The button will lock and the
status LED will change to red.
4. To switch the micorhone back on, press the button again. The status LED will change to green.
The supplied Color Coding Kit includes pre-cut paper strips in various colors that you can assign to the
various channels of a multichannel system. You can write or print additional information (e.g., channel
number, frequency, performer's name, etc.) on each paper strip.
1. Open the battery compartment door (1).
4 Operating Notes
Preset Screen (comes up only
if at least one Preset has been
saved): Carrier frequency as
Subchannel number within a
Frequency Group, battery
capacity bars. If the micro-
phone is ON, the "MUTE"
label is off.
Battery Screen: Battery
capacity in hours and as bar
graph. If the microphone is
ON, the "MUTE" label is off.
4.1.2 SETUP and SILENT
Modes
4.2 Selecting Modes
Note:
4.3 Muting the Microphone
Refer to fig. 1.
4.3.1 Optional Remote Mute
Switch
Refer to fig. 4.
4.4 Changing the Color Code
Refer to fig. 5.
23