Publicidad
Idiomas disponibles
Idiomas disponibles
Precautions for use
o This unit is very heavy, so take care to avoid injury during installation.
o Do not install this unit in a location that could become hot. This
includes places that are exposed to direct sunlight or near a radia-
tor, heater, stove or other heating equipment. Moreover, do not
place it on top of an amplifier or other equipment that generates
heat. Doing so could cause discoloration or deformation.
o In order to enable good heat dissipation, leave at least 20 cm (8")
between this unit and walls and other equipment when installing it.
If you put it in a rack, take precautions to prevent overheating by
leaving at least 5 cm (2") open above the top of the unit and at
least 10 cm (4") open behind the unit.
Failure to provide these gaps could cause heat to build up inside
and result in fire.
o If installing in a rack with a glass door, do not use the remote con-
trol tray OPEN/CLOSE (-) button to open the disc tray when the
door is closed. If the disc tray is forcibly prevented from moving,
damage could result.
o Place the unit in a stable location.
o Do not place anything on top of the unit.
o Do not lift or move the unit during playback because the disc
rotates at high speed. Doing so could damage the disc.
o Always remove any loaded disc before moving this unit or pack-
ing it for installation in a different location, for example. Moving
the unit with a disc inside could cause damage.
o The voltage supplied to the unit should match the voltage as
printed on its back. If you are in any doubt regarding this matter,
consult an electrician.
o Do not open the body of the unit as this might result in damage
to the circuitry or cause electric shock. If a foreign object should
get into the unit, contact your dealer.
o When removing the power plug from an outlet, always pull
directly on the plug. Never pull on the cord itself.
Precaution when recording with a connected
device
Some discs include signals to prevent copying. You cannot record the
digital audio signal as is from a disc that has such copy-protection.
(You can record the audio as an analog signal.)
Maintenance
Use a soft dry cloth to wipe the surface of the unit clean.
For stubborn smudges, use a damp cloth that has been thoroughly
wrung out to remove excess moisture.
o Never spray liquid directly on this unit.
o Do not wipe with chemical cleaning cloths, thinner or other
chemical agents. Doing so could damage the surface.
o Avoid allowing rubber or plastic materials to touch the unit for
long periods of time because they could damage the cabinet.
V
For your safety, disconnect the power cord from
the outlet before cleaning.
7
Publicidad
