Publicidad
Idiomas disponibles
Idiomas disponibles
can also be completed through the Interactive Services menu. To perform the phone test, press [*][6] followed
by the master code and [04].
The panel indicates when the HSPA phone test has completed by activating the siren output on medium volume
for 2 seconds followed by full volume for 2 seconds. However, if the phone test was initiated via the [3] key,
or through the Interactive Services menu, the siren will not sound. All display lights and LCD pixels turn on.
This indicates that Alarm.com has received and acknowledged the signal. This does not guarantee that the sig-
nal went through to a central station; it confirms that Alarm.com's Network Operations Center received the
signal. The central station should be contacted directly to verify that the signal was received on the correct
account and that the central station routing settings have been set up correctly. If the signal does not go through
to the Central Station, the panel will display a "Failure to Communicate" message. Double check the account's
Central Station Forwarding Settings on Alarm.com and contact technical support if the trouble persists.
- 13 -
Publicidad
