RECARO C 6000 Manual De Montaje página 44

Warning:
The screws in the kit are micro-encapsulated and should never to be used more than once.
The micro-encapsulation will become ineffective if they are repeatedly used and the permanent
securing of the screw connection can no longer be guaranteed.
N
Vehicle connections are fitted at the back of the seat
1. Disconnect the venting hose (2) - white - approx. 5 cm in front of the adapter bridge on the inside and
seal this using adhesive tape (hose cutter).
2. Detach the connection of the air supply hose (1) from the adapter bridge (14 mm
socket).
3. Detach the electric plug connection (3) from the adapter bridge on the inside (use a suitable tool to undo
the catch).
4. Activate the express down mechanism.
5. Start the vehicle in order to build up the air pressure needed for the remaining part of the installation.
O
6. Deactivate the express down mechanism.
7. Reset the height adjustment so that it is in the highest position.
RECARO Automotive Seating
RECARO
1 Air supply hose
2 Venting hose
3 Electrical connection

Steering wheel adjustment - front
RECARO seat adjustment - rear, top
mandrel or relevant
Page 19 of 25