RECARO C 6000 Manual De Montaje página 45

P
1
3
4
8. Screw the screws (2) into the adapter (finger tight only).
9. Push the screw (3) through the adapter and screw it into the nut (4) so that it is finger tight.
10. Tightly screw the front screw (2) into the adapter using the stipulated torque (use the T30 Torx adapter).
Torque: M8 screws: 25 Nm ± 2 Nm
11. Tightly screw the screw (3) through the adapter into the nut (4) using the stipulated torque (use the T30
Torx adapter and the SW13 spanner for this).
Torque: M8 screws: 25 Nm ± 2 Nm
12. Now move the seat as far forward as possible.
13. Tightly screw the four screws (5, 6) at the rear using the stipulated torque (use the T30 Torx adapter).
Torque: M8 screws: 25 Nm ± 2 Nm
Danger:
If the torque is not set correctly, the screws will work loose whilst you are driving.
In this case, the safety concept can no longer be ensured and the vehicle may no longer be used.
The screws must be tightened using the stipulated torque.
RECARO Automotive Seating
5
2
1 RECARO seat
2 Front screw - M8 x 12 from installation
kit
3 Front screw - M8 x 35 from installation
kit
4 M8 nut from installation kit
5 Centre screws - M8 x 12 from
installation kit
6 Rear screws - M8 x 12 from installation
6
kit
Page 20 of 25