Stiga Park 300 Manual De Uso Y Mantenimiento página 131

(Translation of the Original Instructions)
disposal facilities for handling and recycling.
• Adhere strictly to local regulations governing
the disposal of cuttings.
• When the machine is withdrawn from service,
do not dump it in the environment, but take it to
a waste disposal facility in accordance with the
local regulations in force.
4 INSURING YOUR LAWNMOWER
Check the insurance on your lawnmower.
Contact your insurance company.
You ought to have fully comprehensive insurance
for traffic, fire, damage and theft.
5 ASSEMBLY
The battery must be fully charged befo-
re being used for the first time.
Do not use the machine until all the in-
dications provided in the "ASSEMBLY"
section have been carried out
Unpacking and completing the assem-
bly should be done on a flat and stable
surface, with enough space for machi-
ne handling and its packaging, always
making use of suitable equipment
5 1 ASSEMBLY COMPONENTS (3)
The machine is delivered with the seat, steering
wheel and bonnet dismantled. The battery is in its
housing but not connected.
The packaging holds the components needed for
assembly (3) as listed in the table below:
Pos. No. Description
A 2 Plug
B 4 Screw
C 2 Shoulder washer
D 2 Ignition key
E 1 Bonnet
F 1 Lifting pulley
G 2 Quick-release supports
- 1 Documentation kit
5 2 BONNET (5)
Open the bonnet to access the fuel cap and
engine oil cap.
Install the bonnet (5:A)
4 Insert the hinge in the groove
guard (5:C).
Dimensions
6 x 36
16 x 38 x 0,5
16 x 38 x 1,0
/
/
/
as follows:
(5:B) on the
ENGLISH
5 Press firmly to get the hinge into the two slots
(5:D)
6 Open and close the bonnet to check that it
opens and closes correctly.
5 3 BATTERY
For the type of battery installed on the machine,
please refer to "0 TECHNICAL DATA TABLE"
WARNING! Battery acid is corrosive
and contact with it is harmful. Handle
the battery with care taking care not to
let acid leak out
5 3 1 Battery connection
Note: To connect the battery, contact an
authorized technical assistance servi-
ce
5 3 2 Battery charging
The battery must be fully charged befo-
re being used for the first time.
Please refer to 9 8 for the battery char-
ging procedure
5 4 SEAT (6)
NOTE! To facilitate installation of the
seat, apply a drop of oil to the four
screws before screwing them in.
1 Remove the following components from the
seat bracket:
• 4 Nuts (for blocking during transport, not
used).
• 4 Screws.
• 2 Shoulder washers.
2 Position the seat on the seat bracket
mounting.
3 Put the shoulder washers
screws.
4 Insert the screws
shers
and the holes on the seat plate as illustrated
in figure 5. Screw the seat into place.
Tightening torque: 24 Nm.
Tightening the screws to a torque over
24 Nm, will damaged the seat.
The seat can be folded. If the machine is parked
outside where it is exposed to rain, fold the seat
(6:A) and the shoulder wa-
(6:B) in the slots on the seat support
EN
(6:B) on the
11