Publicidad
Idiomas disponibles
Idiomas disponibles
EN
forward to protect the seat cushion from getting
wet.
5 5
STEERING WHEEL (7)
Install the steering wheel as follows:
1 Put the sleeve
(7:B)
Align the holes on the sleeves with those on
the steering column using a pin punch
or similar tool.
•
Model V 320: the height position can be
selected from 4 sets of holes. Select the
position which suits you most.
•
Model
V 302
holes.
2 Secure the sleeve to the steering column
using the pins (7:A).
5 6
TYRE PRESSURE
For the tyre pressure, please refer to "0 TECHNI-
CAL DATA TABLE".
5 7
LIFTING PULLEY (8:E)
Thread the cable from the ride-on lawnmower
through the guide on the lifting pulley.
After connecting an accessory to the ride-on
lawnmower, position the lifting pulley in the relative
seat on the accessory and secure in place by
turning the relative knob.
5 8
QUICK-RELEASE SUPPORTS (12)
The quick-release supports and relative installa-
tion instructions are supplied in a separate box
inside the machine packaging.
Install the quick-release supports on the machi-
ne's front axles.
The quick connectors for accessory hook-up
make it possible to:
• swap over accessories quickly and easily.
• easily move the accessory from the working
position to the retracted position:
•
Operating position: the quick-release
supports are in the closed position (12:A).
The accessory is engaged with the drive
belt taut.
•
Retracted position: the quick-release
supports are turned in the open position
(12:B). The accessory goes back by ap-
proximately 4 cm in relation to the working
position. In this position the drive belt is
slack and it is possible to swap over diffe-
rent accessories.
12
on the steering column.
S: use the bottom set of
ENGLISH
5 9
CUTTING-MEANS ASSY
For the assembling/disassembling operations, see
the relative instructions provided in the cutting-me-
ans assy's manual.
5 10 FRONT SWEEPER /BLADE TYPE SNOW
PLOUGH
(7:C)
The following assembly instructions are an
integration to the instructions provided in the
accessory's manual For correct assembly of
the accessory, also follow the instructions in the
relative manuals.
1
Make sure you have installed the quick-
release supports.
2
Position the accessory's hook-up brackets
on the quick-release supports in the open
position.
3
Wind the belt around the machine's pulleys
and tension it (front sweeper only).
4
Install the belt guard and make sure it is in the
correct position (front sweeper only).
5
Connect the lifting pulley to the accessory by
inserting it in the relative seat and securing it
in place using the knob.
6
Close the quick-release supports to the ope-
rating position.
6 1
MECHANICAL ACCESSORY LIFT PE-
DAL
It controls the lift system and is used to take
the accessories from the operating position
to the transport position.
• Transport position: press the pedal right
down then lift your foot off: the pedal stays
down.
• Operating position:
•
Press the pedal right down.
•
Move the locking lever
•
Release the pedal.
The machine is fitted with a safety sy-
stem which makes it impossible to en-
gage cutting devices when they are in
the maintenance or transport position
6 2
PARKING BRAKE PEDAL
Never press the pedal while driving.
There is a risk of overheating in the po-
wer transmission.
(Translation of the Original Instructions)
6 CONTROLS
(8:C)
(8:B)
to the left.
(8:D)
Publicidad
