Publicidad
Idiomas disponibles
Idiomas disponibles
(Translation of the Original Instructions)
8 USING THE ACCESSORY
Make sure the grass to be cut is com-
pletely free of foreign objects such as
stones etc
8 1
CUTTING HEIGHT
For best results, cut off the top third of the grass.
See fig. (15). To adjust the cutting height see
heading 6.9.
If the grass is long and needs cutting back signifi-
cantly, cut twice using two different cutting heights.
Do not use the lowest cutting heights if the lawn
surface is uneven.
This would entail a risk of the cutting devices being
damaged against the surface and the lawn's top
layer of soil being removed.
8 2
MOWING TIPS
To get the best mowing results, follow the tips
given below.
• Cut grass frequently.
• Run the machine at full revs.
• Grass should not be wet.
• Only use sharp cutting devices.
• Keep the bottom side of the cutting device
clean.
9 MAINTENANCE
9 1
ASSISTANCE PROGRAMME
To keep the machine in good working order in
terms of reliability, safety and environmental pro-
tection, always adhere to the STIGA SpA servicing
programme.
The points of intervention for this programme are
illustrated in the attached STIGA SpA maintenan-
ce manual.
The Basic Service must always be carried out by
an authorized service workshop.
All assistance interventions not listed
in this chapter must be carried out
exclusively by an authorized technical
assistance centre
The checks carried out by an authorized service
workshop guarantee professional workmanship
and the use of genuine spare parts.
The handbook is stamped every time a Basic Ser-
vice is performed and each time an Intermediate
Service is carried out by an authorized service wor-
kshop. A handbook with these stamps increases
ENGLISH
the second-hand value of the machine.
9 2
PREPARATION
All service and all maintenance checks must be
carried out on a stationary machine with the engine
switched off.
All service and all maintenance checks
must be carried out on a stationary ma-
chine with the engine switched off.
Always apply the parking brake to stop
the machine from moving
Stop the engine
9 3
MAINTENANCE TABLE
See chapter "13 MAINTENANCE SUM-
MARY TABLE" The table is designed to
help you keep your machine in efficient
and safe working order. It indicates the
main operations to be performed and
the frequency of the same Perform the
relative operation described based on
the first deadline to arrive.
Change the oil more frequently if the
engine has to work in difficult condi-
tions or when the ambient temperature
is high
9 4
TYRE PRESSURE
Adjust the tyre pressure to meet the values provi-
ded in "0 TECHNICAL DATA TABLE".
9 5
ENGINE OIL TOP-UP/CHANGE
9 5 1 Inspection / top-up (14)
Always check the oil level before use. To
check the level, make sure the machine
is on even ground
For the type of oil to use please refer to "0 TECHNI-
CAL DATA TABLE".
Use oil with no additives.
Open the cover (13:B).Wipe around the
dipstick. Unscrew it and pull it out. Wipe the
dipstick clean.
Push the dipstick down completely and
screw in place.
Now unscrew and pull the dipstick up again.
Read off the oil level.
Top up if the level is lower than the "FULL"
mark (14).
EN
17
Publicidad
