Descargar Imprimir esta página

Toro Recycler 56 Manual De Instrucciones página 13

Ocultar thumbs Ver también para Recycler 56:

Publicidad

Idiomas disponibles

Idiomas disponibles

Removing the Side-Discharge Chute
To remove the side-discharge chute, lift up the side door,
remove the side-discharge chute, and lower the side-discharge
door.
Operating Tips
General Mowing Tips
Inspect the area where you will use the machine and
remove all objects that the machine could throw.
Figure 21
Avoid striking solid objects with the blade. Never
deliberately mow over any object.
If the machine strikes an object or starts to vibrate,
immediately shut off the engine, disconnect the wire from
the spark plug, and examine the machine for damage.
For best performance, install a new blade before the
cutting season begins.
Replace the blade when necessary with a Toro
replacement blade.
Cutting Grass
Cut only about a third of the grass blade at a time. Do not
cut below the 54 mm (2-1/8 inch) setting unless the grass
is sparse or it is late fall when grass growth begins to slow
down. Refer to
When cutting grass over 15 cm (6 inches) tall, mow at the
highest cutting height setting and walk slower; then mow
again at a lower setting for the best lawn appearance. If
the grass is too long, the machine may plug and cause
the engine to stall.
Wet grass and leaves tend to clump on the yard and can
cause the machine to plug or the engine to stall. Avoid
mowing in wet conditions.
Be aware of a potential fire hazard in very dry conditions,
follow all local fire warnings, and keep the machine free
of dry grass and leaf debris.
Alternate the mowing direction. This helps disperse the
clippings over the lawn for even fertilization.
If the finished lawn appearance is unsatisfactory, try 1
or more of the following:
– Replace the blade or have it sharpened.
– Walk at a slower pace while mowing.
– Raise the cutting height on your machine.
– Cut the grass more frequently.
g009537
– Overlap cutting swaths instead of cutting a full swath
with each pass.
Cutting Leaves
After cutting the lawn, ensure that half of the lawn shows
through the cut leaf cover. You may need to make more
than a single pass over the leaves.
Slow down your mowing speed if the machine does not
cut the leaves finely enough.
12
Adjusting the Cutting Height (page
9).

Publicidad

loading

Este manual también es adecuado para:

20379