Installation, use and maintenance manual
---- - WOOD BURNING STOVES
7 7
CLEANING AND MAINTENANCE
CLEANING AND MAINTENANCE
The stove requires simple and frequent cleaning to guarantee maximum efficiency and correct operation.
The Buyer must carry out regular cleaning of the stove following the instructions contained in this Instruction Manual, and in
particular must carry out daily cleaning before each ignition or refilling of pellets, the ash drawer, the fire pit and the
combustion chamber.
Failure to clean and/or routinely maintain the stove can cause: malfunctions, clogging of the burn pot and pipes, poor or slow
combustion, overheating of the stove and fire in the tank.
ATTENTION
ATTENTION
Eva Stampaggi S.r.l. assumes no criminal and/or civil liability, direct and/or indirect for the malfunction of the stove
and for damage to persons or property caused by the failure/incorrect cleaning and routine maintenance of the stove.
ATTENTION
ATTENTION
Perform cleaning with the stove completely cold.
daily cleaning
daily cleaning
Empty the ash drawer, vacuuming it out or throwing the ash into the rubbish or use it as fertiliser. Use a flame retardant
container.
Depending on the hours of operation and the quality of the wood, check the amount of ash in the combustion chamber and if
necessary remove or vacuum it out. Use a flame retardant container.
Vacuum the combustion chamber, ensuring that there are no burning embers remaining. If embers are still burning, the
vacuum cleaner will catch fire;
weekly cleaning
weekly cleaning
Remove the ash that collects inside the fire box and on the door.
Clean the glass with a damp cloth or with a ball of damp newspaper dipped in ash. If the operation is performed with the stove
hot there is a risk of the glass exploding. Do not use harsh or abrasive chemicals. Use newspaper with water and little ash.
Empty the ash drawer, vacuuming it out or throwing the ash into the rubbish or use it as fertiliser. Use a flame retardant
container.
External cleaning of the stove
External cleaning of the stove
Only use a dry cloth to clean the stove. Do not use abrasive material or products that could corrode or bleach
surfaces. At the end of the season, with the last ignition, the pellet remaining in the auger must be consumed
completely. The auger must remain empty to avoid clogging due to solidified sawdust residue created by moisture.
83103600 - 1.0 - 14/12/2022
EN
EN
18
18