Casals CID2050B Manual Del Usuario página 13

PRODUCT DESCRIPTION AND
SPECIFICATIONS
DESCRIPTION
A Keyless Chuck
B Torque adjustment ring
C Function selector ring
D Gear selector
E Cooling vents
F Forward/Reverse selector
G On/Off switch
H Handle with soft grip
I LED light
J Battery
K Battery release button
L Battery charge level indicator button
M Plug socket
N Charger
O Charger Jack
If the model of your appliance does not have
the accessories described above, they can
also be bought separately from the Technical
Assistance Service.
CHARGING THE BATTERY
Caution: A new battery is not fully charged
and must therefore be charged before the
appliance is used for the first time.
Plug the charger (N) into the mains.
Connect the charger jack (O) to the socket on
the battery (M). The socket is located at the top
of the battery.
When the battery is charged (will show green
light) disconnect the charger from the mains
supply.
NB: Do not use the appliance while it is
connected to the charger.
HOW TO CHECK THE BATTERY'S CHARGE
LEVEL:
Press the battery charge level indicator button
(L), the pilot lights that indicate if it is charged
will light up.
If all three pilot lights light up this means that
the appliance is fully charged.
If only two of the pilot lights light up this means
that the battery is half charged.
If only one pilot light lights up this means that
the battery has very little power remaining.
If no pilot light lights up, this means that the
battery is completely discharged.
NB: For a long battery life, it is advisable
to charge the battery, before it runs out
completely.
ASSEMBLING THE BATTERY
Align the battery with the base of the drill, and
slide it along the guides until you hear a click.
INSTRUCTIONS FOR USE
INSERT A DRILL BIT:
To open the drill's chuck, whilst completely
switched off, take firm hold of the back part of
the chuck and turn the front part of the chuck
counter clockwise.
Insert the drill bit, screwdriver bit, or other tool/
accessory required for the task, into the chuck.
In order to obtain a secure fastening of the bit,
insert the bit as far as you can into the chuck.
Take firm hold of the back part of the chuck and
turn the front part of the chuck clockwise until it
is firmly closed.
In order to remove accessories from the chuck,
follow the same steps as indicated previously
but in reverse order.
BEFORE USE:
Ensure that every part of the packaging has
been removed.
Ensure that battery is charged and mount it
according to the instructions.
Select the direction you want to use using the
Forward / Reverse Selector (F).
Select the torque needed if you are
screwdriving, or select the function you desire
using both torque adjustment ring (B) and
function selector ring (C).
Insert the accessory you need according to
previous instructions.
USE:
Turn the appliance on, by using the on/off
switch (G).
LED light (I) will assist you on your view and
power indicator lights will lighten up showing
the actual level of the battery.
Perform the operation needed by pressing onto
the surface you desire to drill or screwdriving
the screws needed.
ELECTRONIC SPEED CONTROL:
The speed of the appliance can be regulated
by releasing or applying pressure on the On/Off
switch. This function is very useful, as it makes
it possible to adapt the speed of the appliance
to the type of work that needs to be done.