Casals CID2050B Manual Del Usuario página 14

SPEED CHANGE
The appliance has 2 gear settings to change
mechanical speeds
1st speed: Switch the gear selector until it
shows 1
2sd speed: Switch the gear selector until it
shows 2
DRILLING, DRIVING AND IMPACT DRILLING
Drilling (wood, steel ...):
Turn the function selector ring until points to (
).
To drill, ALWAYS have the direction set to
clockwise (CW).
Impact drilling
Turn the function selector ring until the arrow
on the appliance points to (
Screwdriving
Turn the function selector ring until the arrow
on the appliance points to (
To screw, ALWAYS have the direction set to
clockwise (CW).
To unscrew, set the direction to counter
clockwise (CCW).
The appliance should not be in use when
changing the screwing direction.
Set the torque setting in order to adjust the
power to be applied in the screws.
SAFETY LOCK:
The safety lock position stops the on switch
from activating; it prevents the appliance from
being switched on accidentally.
To activate this function, place the Forward/
Reverse selector in the middle position.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
Check the status of the battery. If battery is not
fully discharged, you can keep it mounted. If
battery is discharged, connect it to the charger
according the instructions before.
Clean the appliance.
CLEANING
Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an
acid or base pH such as bleach, or abrasive
products, for cleaning the appliance.
A good way to clean and extend product life is
to shoot it with compressed air, to remove all
dirtiness in a dry way.
Never submerge the appliance in water or any
other liquid or place it under running water.
SUPPLIES
Supplies can be acquired from distributors and
authorised establishments for your appliance
model.
Always use original supplies, designed
specifically for your appliance model.
ANOMALIES AND REPAIR
Take the appliance to an authorised technical
support service if product is damaged or other
)
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
If the connection to the mains has been
damaged, it must be replaced, take the
)
appliance to an authorised technical support
service. Do not attempt to disassemble or
repair the appliance by yourself in order to
avoid a hazard.
SPECIFICATIONS:
Internally powered equipment: The lithium
battery
Rated voltage: 20V
No load speed: n0:0-400/0-1400/min
Spindle thread:1/2"-20UNF
Weight: 1.328 Kg
Sound Pressure level (LpA) =82,0 dB(A), KpA
= 5 dB
Sound Power level (LwA) =93,0 dB(A), KwA =
5dB
for impact drills with drill only function:
Vibration= 9,506m/s
for drills: Vibration =1,659m/s
Continuous operation with short-time loading
Not suitable for use in presence of flammable
anaesthetic mixture with air or with Oxygen or
nitrous oxide
NB: These specifications are subject to change
without notice of purpose of improvement.
NB: By virtue of the conditions of fabrication
of this product, the maximum absorbed power
can differ from that specified.
NB: By virtue of the conditions of fabrication
of this product, the maximum used power can
differ from that specified.
, K=1,5 m/s
2 2
, K= 1,5m/s
2 2