Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTAINING & CLEANING
All the maintenance must be held after the unit is shut off. Clean the dust cup regularly to
avoid any problems. It is recommended to dry storage and not to put heavy things on the unit.
Cleaning the dust container: (FIG. 8)
1. Press the dust container release button to take the dust container out.
2. Press the dust release button to open the bottom cover and expel trash. Wipe to clean
the dust container, do not immerse in water.
Cleaning the filter: (FIG. 9)
1. Remove the dust container from the main body.
2. Hold the filter and pull it out upwards from the dust container.
3. Lift to remove the sponge filter and high-efficient filter.
4. Rinse the filters thoroughly under the running cold water. Do not use soap or other cle-
aning solvents.
5. COMPLETELY air dry the filters before reassembling. Do not use hair dryer to dry the
filter. This may cause the filter to warp.
Filters re-assembly: (FIG. 10)
Important: Make sure the filters assembled rightly, otherwise, the fine dust will come into
the motor and destroy it.
Fix the filters into the dust cup and make the right way to fix them as it is shown on the
picture (Fig. 10).
Cleaning the roller brush: (FIG. 11)
1. Remove the motorized power brush from the main unit before cleaning the roller brush.
2. Release the button and pull it out.
3. Rotate the cover and pull out the roller brush.
4. Carefully clean and remove the hairs and debris from the brush roller. Wipe to clean
only, do not use any soap or harsh cleaning solvents.
5. If roller brush becomes damp, allow to dry naturally before replacing.
TROUBLESHOOTING
PROBLEM
Appliance is
not power on
Vacuum is sto-
pped suddenly
26
POSSIBLE CAUSES
This can occur if the applian-
ce has been used or stored
for an extended period of
time
This will occur if the safety
cut-out device has been acti-
vated. This device is designed
to prevent your appliance
from overheating
SOLUTION
Connect the vacuum to the charger
and allow for a full charging cycle to
complete
Ensure the vacuum is turned off,
disconnect all accessories and leave
to cool down for at least half an hour
before attempting to operate again. Try
to identify the source of the overheat by
checking for blockages in the extension
tube motor-drive floor head and acces-
sories. Empty the dust container and
clean or replace the filter
Publicidad
