Suction of the
vacuum is
reduced
Motorized
power brush is
not rotating
Charging
indicator light
does not flash
up
Application
time of the
vacuum is less
than it used
to be
PRODUCT DISPOSAL
This product complies with European Directive 2012/19/EU on electrical and
electronic devices, known as WEEE (Waste Electrical and Electronic Equip-
ment), provides the legal framework applicable in the European Union for the
disposal and reuse of waste electronic and electrical devices. Do not dispose
of this product in the bin, instead going to the electrical and electronic waste
collection centre closest to your home
The product may contain batteries. Remove them before disposing of the pro-
duct and dispose in special containers approved for this purpose.
This is probably caused by
dust blockages
This tends to occur when
there are too many fibers
wrapped around the brush
roll restricting movement
There may be no power rea-
ching the vacuum from the
charger
An insufficient charging cycle
will result in reduced appli-
cation time.
Turn the vacuum off. Disconnect the
floor head, extension tube and any
accessories. Check for and remove any
blockages from the dustbin filter, air
duct, extension tube floor head and
accessories
Check the maintenance section of this
manual for instructions on how to
appropriately clean the brush roll
Ensure that power is being supplied to
the mains socket and that the charger
is turned on. Ensure the charging
cable is securely connected to the
vacuum. Ensure the mains socket
is switched off before checking the
charging cable itself. Do not attempt
to use if the cable is split, frayed or
otherwise damaged. Instead, seek a
replacement charger
Ensure the battery has completed a
full charging cycle. There may be re-
duced energy discharge in the battery.
This is normal and gradually occurs in
all batteries over time
27