Machine Operation; Pre-Operation; Cleaning Carpets; While Operating - Nobles Marksman 412 Manual Del Operador

OPERATION
7. Plug machine's power cord into a grounded wall
outlet (Figure 4).
Grounded
3 Hole Outlet
Ground Pin
(120V)
FIG. 4
FOR SAFETY: Do not operate machine unless
cord is properly grounded.
FOR SAFETY: Do not operate machine with the
use of an extension cord.

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
PRE–OPERATION
1. Vacuum carpet and remove other debris.
2. Perform MACHINE SETUP procedures.
3. Inspect power cord for damage.

CLEANING CARPETS

1. Turn main power switch on (Figure 5).
FIG. 5
2. To begin cleaning carpets, pull triggers and slowly
pull machine backwards (Figure 6).
6
Grounded Outlet
Grounding
Edge/hole
(230V/240V)
Home Find... Go To..
FIG. 6
3. Release triggers at end of path and continue to
pull machine to pick up excess solution.
4. Tip machine back on wheels and push machine
forward to begin next path.

WHILE OPERATING

1. Overlap each path by 50 mm (2 in).
WARNING: Flammable materials or reactive
metals can cause an explosion or fire. Do not pick
up.
2. Work away from wall outlet and power cord to
prevent cord damage.
3. Periodically check for excessive foam buildup in
recovery tank. Use a recommended foam control
solution to prevent vacuum motor damage.
ATTENTION: Excessive foam buildup will not
activate the float shut-off screen.
4. If brush stops, the circuit breaker may have been
tripped. Unplug power cord, check brush for
obstruction. Push brush reset button to resume
(Figure 7).
FIG. 7
5. To clean heavily soiled areas, repeat cleaning path
from different direction.
6. Observe recovery site window, when recovery
appears to stop, drain recovery tank (See
DRAINING TANKS).
Marksmant 412 (01–01)