Filling Solution Tank; Machine Operation; Pre-Operation Checks - Nobles Speed Scrub 2401 Manual Del Operador Y Piezas

OPERATION
FIG. 9
NOTE: Always make sure pad drivers and motor hub
surfaces are always clean before installing drivers.
Clean surfaces will ease pad driver removal later.
8. Close skirt housing and refasten latch.

FILLING SOLUTION TANK

1. Transport machine to filling station. Raise
squeegee and brush when transporting.
2. Turn main switch to the off position.
3. Open solution fill door at front of machine and fill
solution tank with 64L (17 gal) of clean water,
60°C (140°F) maximum temperature. Or use the
rear fill port to fill solution tank. Twist off plug and
insert hose to fill. The clear tube below the fill port
has 19L (5 gal) increment markers to indicate
amount of water in tank (Figure 10).
FIG. 10
NOTE: If filling with a bucket be certain that bucket is
clean. This will prevent possible solution line clogs.
4. Add cleaning chemical. See proper dilution ratio
instructions on bottle.
FOR SAFETY: When using machine, follow mixing
and handling instructions on chemical containers.
ATTENTION: Use only recommended cleaning
chemicals, DO NOT use substitutes. Consult an
authorized distributor for recommendations.
WARNING: Flammable materials can cause
an explosion or fire. Do not use flammable
materials in tank(s).
8
Home Find... Go To..

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
PRE–OPERATION CHECKS
S
Sweep and dust mop floor to remove particles and
other debris.
S
Check battery meter charge level to ensure
batteries are fully charged (See BATTERY
CHARGING).
S
Check condition of pads or brushes.
S
Check condition of squeegee blades.
1. Release parking brake lever if set.
2. Adjust control grips to a comfortable operating
height, squeeze together the two levers below the
console (Figure 11).
FIG. 11
3. Disengage squeegee lift lever from the up position
and lower squeegee (Figure 12).
FIG. 12
4. Turn main switch to the on position.
Speed Scrubt 2401/2601 (08–01)