Publicidad
Idiomas disponibles
Idiomas disponibles
3
BASE INSTALLATION
3a. Place base into position and check for level in several directions. (Figure C)
NOTE: If base is not level, shim or level sub floor. Once base is level, draw a line on the wall studs above
the base flange. .
4
NO BEDDING
MATERIAL UNDER
BASE FLANGE
BEDDING MATERIAL
SUPPORTS
SHOWER BASE
FIGURE C
FIGURE D
Mix a non-shrinking bedding material such as mortar and apply enough bedding material to support the
entire bottom of the shower base.
Concrete is NOT recommended. The shower base is NOT to be supported by the base flange.
Level
Level base in two directions.
FIGURE C
CROSS SECTION OF
SHOWER BASE
Bedding
Material Area
5" (127mm)
Level
ROUND SHOWER
STRAINER TYPE DRAIN
2 x 4"
2" (51mm)
(51 x 102mm)
PVC Pipe
Stud Wall
Publicidad
