Publicidad
Idiomas disponibles
Idiomas disponibles
POST INSTALLATION CLEAN-UP
Remove all construction debris. Tile grout can be removed with a wooden popsicle stick or tongue depressor.
Do not use wire brushes or any other metal implement on bath surface.
Post installation clean-up generally can be completed using warm water and liquid dishwashing detergent.
Stubborn dirt or stains may be removed using granular Spic and Span
Painter's naphtha can be used to remove excess adhesives and/or wet oil-base paint.
AFTERCARE AND CLEANING
• Excessively hot water may cause surface damage.
• HARSH CHEMICALS SHOULD NEVER BE USED ON SHOWER BASE SURFACE. Clean after use with a
mild liquid household detergent cleaner. Do not use Lestoil, Lysol Disinfectant (spray or concentrate), or Lysol
Basin, Tub and Tile Cleaner, Windex, Mr. Clean, Dow Disinfectant Bathroom Cleaner, or cleaning products in
aerosol cans.
• Do not use wire brushes, knives or sharp objects to remove stains, cigarette tar deposits, or other surface
blemishes.
• Abrasive cleaners or powders must not be used, since they will dull the surface. If the glossy surface loses
its sheen, dulled areas or light scratches can be restored by rubbing with a white "automotive type" polishing
compound and waxing with a "liquid wax."
• Do not wax areas where you walk or stand.
• Do not allow nail polish remover, acetone, dry cleaning fluid, paint remover or other solvents to come into
contact with the surface.
• Clean the surrounding surface immediately after using caustic drain cleaners.
• Burning cigarettes will damage the surface.
• Should damage to the fixture occur, repairs can be made quickly and easily. Your distributor or builder can
provide details.
Spic And Span
Is A Registered Trademark Of The Spic And Span Company
®
mixed with water.
®
Publicidad
