Publicidad
Idiomas disponibles
Idiomas disponibles
4 INSTALLATION
4.1 Install Mounting Feet to Back of Enclosure
The 61N00 is shipped with mounting feet and installation hardware.
1. Turn the enclosure so the back side is visible. Then place the mounting feet over the octagon
pieces (you can place the mounting feet horizontally, diagonally, or vertically) and fasten them
with the ¼ in. -20 x 0.25 in. SS, countersunk Phillips drive screws (torque limit is 30 in. lbs.).
Enclosure Mounting Feet Positions (Vertical, Horizontal, and Diagonal)
2. Position enclosire vertically (i.e. on a wall) or horizontally (i.e. on a table top).
3. Mount unit using #10-32 3/4 in. panhead screws and screw directly in the
center of the cross on mounting feet.
Center of Crosshair Indicates Screw Mounting Location
Mounting Feed and Installation Hardware
4
Publicidad
