Multiplex EasyGlider 4 Instrucciones De Montaje página 19

3. Install the receiver
See paragraph 4.3 of the building instructions.
4. Assemble the model
See paragraph 5 of the building instructions and Fig. 33.
5. Set the correct control surface travels and Centre of Gravity
See paragraphs 7 and 8 of the building instructions and Fig. 34.
6. Go flying with the EasyGlider 4
See paragraphs 9 and 10 of the building instructions and Figs. 35 - 40.
Parts List RR EasyGlider 4
No. Quantity
1 1
2 1
3 1
4 1
5 1
6 1
7 1
8 1
9 1
10 1
11 1
12 1
# 21 4332
Essential / recommended accessories:
Airborne radio control system components / other accessories
MULTIPLEX receiver RX-5 light M-Link
or MULTIPLEX receiver RX-5 M-Link (telemetry capable)
2x servo Tiny-S (elevator/rudder)
2x servo Nano-S (aileron)
2x Servo extension lead 300mm
2x Servo extension lead 150mm
Power set
Power set „EasyGlider 4"
with ROXXY C28-34-850kv brushless motor and
ROXXY BL-Control 720 S-BEC speed controller
Battery
LiPo ROXXY EVO 3-2200 20C (M6)
Adhesives
Zacki ELAPOR® 20g
Zacki ELAPOR® Super liquid 10g
Hot-melt adhesive
Battery charger
12V/230V Power Peak B6
Tools required
Balsa knife, side-cutters, screwdrivers (for M3 and M5 slot-head screw, and M2.5 cross-point screw), pliers, 13 mm A/F spanner,
320-grit abrasive paper, hot-melt glue gun.
Description
EasyGlider 4 building instructions
Complaint processing form
Fuselage with servos and power set
L.H. wing with servo
R.H. wing with servo
Tailplane
Fin
M5 plastic screw
Allen key, 1.5 mm A/F
Hook-and-loop tape, hook
Hook-and-loop tape, loop
Foam block battery retainer
Order No. 5 5808
Order No. 5 5817
Order No. 6 5121
Order No. 6 5120
Order No. 8 5031
Order No. 8 5019
Order No. 33 2672
Order No. 31 6655
Order No. 59 2727
Order No. 59 2728
Order No. 30 8561
19