Tristar AC-5560 Manual De Usuario página 10

Instruction manual
Dehumidifying operation
• Press the "Mode" button until the "dehumidify indicator lamp"
blinks.
• The temperature will automatically be selected.
• The fan speed will automatically be selected.
Heating operation
• Press the "mode" button till the "Heat" icon appears.
• Press the or button to select a desired room
temperature.
• Allow around 5 minutes for the heating to start.
• Press the "fan speed" button to adjust airflow.
Timer operation
Timer ON setting
• When the air-conditioner is OFF, press the "Timer" button and
select a desired ON time and adjust using the temperature
buttons.
• The ON time can be adjusted to anytime in 0-24 hours.
Timer OFF setting
• When the air-conditioner ON, press "Timer" button and select a
desired OFF time through the temperature buttons.
• The OFF time can be adjusted to anytime in 0-24 hours.
Drainage
• After a lengthy operation and before storage, you will need to
drain the water that has been collected. Please prepare a suitable
location or tray to collect the water and remove the rubber stop
from the drainage hole at the bottom of the unit. The water will
then begin to drain. After this has stopped, you can insert the
drain stop.
10
• You can connect a drainage hose that will allow continuous
drainage of the water. Remove the rubber stop and connect a
suitable hose. This hose needs to be directed outside or into a
suitable drain. Please keep in mind that the water will stream
downwards and never upwards.
Internal Tank Water Full Alarm Function
• The inner water tank in the air-conditioner has one water level
safety switch that controls the water level. When the water level
reaches an anticipated height, the water full indicator lamp lights
up. Follow above steps to drain the water.
INSTALLATION
• The air-conditioner should be installed on a flat and stable
surface. Do not block the air outlet and allow at least 30cm
around the unit.