Plustek OpticFilm 120 Guía Rápida página 17

Insert the Film Holder
Insert the film holder into the scanner through the Front Film Holder Slot until it is
automatically pulled in by the scanner. The scanner will not pull in the film holder if the
USB cable is disconnected.
Please allow about 35 cm in front of the scanner to insert and remove the film holder.
If the film holder is stuck inside the scanner, please eject the film
holder by pushing it through the device until it can be removed
Caution
from the Rear Film Holder Slot.
Attention
The film holder should be able to be inserted into the scanner
smoothly. Do not push the film holder hard.
On the top side of the film holder you can see '35 mm
Mounted Film Holder' or '35 mm Strip Film Holder' or '120/220
Strip Film Holder'. Always keep this side up for correct scan
results.
17