Plustek OpticFilm 120 Guía Rápida página 5

Scanner Overview
Logo LED: It indicates the scanner status.
Power Button: Press the button to turn the scanner ON or wake it up from sleep
mode. Press and hold the button for 2‐3 seconds to turn the scanner OFF.
Logo LED Power button
(blue) LED (orange)
On
On
Off
Off
Eject Button: Use this to eject the currently inserted film holder.
Front Film Holder Slot: Insert the film holder into the scanner through dust cover.
Rear Film Holder Slot: Manually remove the Film Holder through the Rear Film
Holder Slot if it does not eject through the front automatically.
Protection Cover: Protects the Rear Film Holder Slot, the Power Receptor and
USB Port. Open the Protection Cover to use the scanner.
USB Port
Power Receptor
You will need the 15 digits Serial Number for SilverFast software
activation. You will also need it when you contact your dealer or our
Attention
service center in the future.
Off The scanner is turned on and operating normally.
The film holder has been ejected and can be
Blinking
removed.
On The scanner is in sleep mode.
The scanner is off, either because the power is not
Off turned on, or because the AC adapter is not
properly plugged into an AC power outlet.
Status
5