Publicidad
Idiomas disponibles
Idiomas disponibles
CYLINDER SPECIFICATIONS
1. Cylinder purchased or exchanged for your gas grill must be manufactured and marked in accordance with the
specifications for LP Gas cylinder of the U.S. Department of Transportation (DOT) or the National Standard of
Canada, CAN/CSA –B339, Cylinders, Spheres and Tubes for Transportation of Dangerous Goods and
Commission, be equipped with a listed over-filling prevention device (OPD), and be equipped with a cylinder
connection device compatible with connection for outdoor cooking appliances.
2. The LP gas cylinder used for this appliance must not have a capacity exceeding 20 lb. (9.1 kg). Approximately
18" (45.7cm) high and 12" (30.5cm) diameter.
3. This grill is designed to fit Worthington, Manchester, or SMPC brand 20 lb. (9.1 kg) cylinders. Other brands
may fit this grill if the top collar and bottom support ring have similar dimensions.
The cylinder must also be equipped with:
1. A shut-off valve terminating in a Type 1 gas cylinder valve outlet
2. A Type 1 valve that prevents gas flow until a positive seal is made
3. A collar to protect the cylinder shut-off valve
4. A safety relief device that is directly linked with the vapor space of the cylinder
A frosty cylinder valve indicates possible gas overfill. Close the LP valve and call your LP dealer immediately.
1. DO NOT connect this grill to an existing #510 POL cylinder valve with left-hand threads. The Type 1 valve
can be identified by the large external threads on the valve outlet.
2. DO NOT connect to a propane cylinder exceeding this capacity.
3. DO NOT connect to a cylinder that uses any other type of valve connection device.
CONNECTING REGULATOR TO LP CYLINDER
Only use the gas pressure regulator provided with this outdoor cooking appliance. This regulator is set for
an outlet pressure of 11 inches water column.
Your regulator is equipped with a QCC Type 1 quick connect system. It does not allow gas to flow until a positive
seal has been made. It has a thermal element that will shut off the gas flow if the temperature reaches
115 °C (240 °F). It also has a flow-limiting device that restricts the flow of gas to 0.28 cubic metrics per hour
(10 cubic feet per hour). Before each use, check the gas hose for excessive abrasion, wear, or cuts.
Replace a damaged hose assembly with the one specified in the parts list before using the grill.
1. Make sure the LP cylinder is OFF by turning the hand wheel clockwise until it stops.
2. Place the cylinder under the gas grill body with the valve facing outward. See Assembly instructions to secure
the cylinder into the nesting hole located in the bottom shelf of the gas grill body.
3. Be sure all burner controls are turned to the OFF position.
4. Remove the safety cap from the cylinder valve.
5. Center the regulator nipple into the cylinder valve.
6. Turn the coupling nut clockwise until it stops. Hand tighten Only. Do not use a wrench.
!
WARNING
!
!
CAUTION
6
!
Publicidad
