Message For Replacing Mechanical Unit; Cleaning The Micr Mechanism - Epson TM-J7000 Manual Del Usuario

English

Message for Replacing Mechanical Unit

The following message will be printed every time the printer is turned on when
the pump unit is near the end of its life. Please follow the instructions in the
message.
Caution: The pump unit must be replaced.
Contact a qualified service person.
MICR Reading (Factory installed option only for the
TM-J7000/J7100)
CAUTION:
Do not insert checks with staples in them. This may cause paper jams, MICR
reading errors, and damage to the MICR head.
Never open the roll paper cover while the MICR reader is being used.
Be sure the checks are flat, without curls, folds, or wrinkles.
Do not use multipart checks.
Wait until the CUT SHEET LED flashes. Then insert the check face up with the
1.
right side of the check against the right side of the paper guide as far as it will
go. Be sure that the MICR characters are on the right, as shown by the arrow
in illustration L.
2. The printer will detect the check and start drawing it in. When the printer
starts drawing it in, let go of the check immediately. When the printer ejects
the check and the CUT SHEET LED starts flashing again; remove the check by
pulling it straight up; do not pull it at an angle.

Cleaning the MICR Mechanism

Approximately every 12 months clean the MICR head with a moistened cleaning
sheet.
Use the following or an equivalent commercially available cleaning sheet:
PRESAT brand (KIC) "CHECK READER CLEANING CARD."
Note:
Be sure not to use an adhesive cleaning sheet.
Follow the steps below:
1. Load roll paper in the printer; turn off the power; then open the roll paper
cover and turn the power back on while holding down the CLEANING
button.
2. Press the CLEANING button 7 times; then close the paper roll cover. The
printer prints the following message on the roll paper and the CUT SHEET
LED flashes.
10 TM-J7000/J7100 – TM-J7500/J7600 User's Manual
**** RECOGNITION MODE
Please set check.
****