cecotec bolero COOLMARKET COMBI 250 WHITE D Manual De Instrucciones página 66

ENGLISH
and away from heat sources. Do not place the refrigerator near heat sources, like a
cooker or pot, and avoid direct sunlight to ensure the cooling effect and save on energy
consumption. Do not place the refrigerator in a damp place, to avoid rust or loss of power.
The result of dividing the total space of the room in which the refrigerator is installed by
the amount of refrigerant load in the refrigerator must not be less than 8 g/m³.
- Note: The amount of refrigerant used by the refrigerator is specified on the rating plate.
Heat dissipation space
During operation, the refrigerator releases heat into the environment. Therefore, you should
leave at least 30 mm of free space at the top, more than 100 mm on both sides, and more than
50 mm at the rear of the refrigerator. Fig. 2
Width Depth (mm)
(mm)
540 576
Note: figure 2 only illustrates the space required for the product.
Stable surface
Place the refrigerator on a solid, flat surface (the floor) to keep it stable, otherwise vibrations
and noises will occur. When the refrigerator is placed on a carpet, straw mat, polyvinyl chloride,
solid support plates should be placed under the refrigerator to avoid colour change due to heat
dissipation.
Preparing for use
Waiting time
Once the refrigerator is properly installed and cleaned, do not switch it on immediately. Be sure
to wait at least one hour before switching it on to ensure normal operation.
Cleaning
Check the placement of the interior accessory parts and clean the inside with a soft cloth.
On
Connect the plug into a power socket to switch on the compressor. After one hour, open the
freezer door: if the temperature inside the freezer compartment has clearly dropped, the
cooling system is operating normally.
Food storage
After the refrigerator has been in operation for some time, the user may adjust its internal
temperature. Once the refrigerator has reached a suitable interior temperature, put in the food.
66
Height A (mm)
(mm)
1810 845
B (mm) C(°)
1110 125+/- 5
E (mm) F (mm)
50 100