VITO POWER VIBCSCB16520 Manual De Instrucciones página 32

Question/Problem - Cause
Cause
The circular saw does not start when you press the ON/OFF
switch:
• The battery is discharged;
• "ON/OFF" switch electrical contacts are not in good
condition or it does not work;
The "ON/OFF" switch is locked:
• "ON/OFF" switch lock/unlock button is not pressed;
The cutting depth is below the set depth:
• There is sawdust accumulated under the base plate;
The blade vibrates or slips during operation:
• The blade is not properly secured;
The blade does not cut straight:
• The blade is not sharp;
• The blade is installed incorrectly;
• The circular saw is not being guided properly;
Solution
• Recharge it;
• Repair or replace the switch;
• Press the ON/OFF switch lock/unlock button;
• Clean the base plate;
• Tighten the bolt;
• Install a sharp blade on the circular saw;
• Check that the blade is installed correctly;
• Use the parallel guide;