Publicidad
Idiomas disponibles
Idiomas disponibles
4-WIRE
SYSTEM
CONNECTIONS
Remove
the ground strap screw from the terminal
block
support.
Fold the ground strap over so both ends of the
ground
strap will be attached
to the center terminal
block
post.
Connect
the neutral
(white) conductor
of the cord to the
center (silver) post of the terminal
block.
Connect
the
grounding
(green) wire of the cord to the terminal
block
support
using the ground strap screw.
Connect
the red and black wires of the cord to the outer
posts of the terminal
block.
Be sure the terminal
block nuts are on tight.
Secure
the
power cord in position.
Tighten
the strain relief screw(s)
in
order to clamp the strain relief to the cord.
Replace
the
terminal
block cover.
EXPORT
MODELS
Neutral
VAC
240/208
VAC
4-Wire System with
Power Cord Attached
'3
]
Folded
I
Ground
Strap
L
I
Strain
relief
Refer to the Additional
Instructions
Section.
7,
With a level, check the dryer,
and make necessary
adjustments
to the leveling
legs.
Once level, tighten the
leveling
leg locking nuts with a wrench.
8,
The dryer door direction
can be reversed.
1. If the dryer is plugged
in, unplug from electrical
service.
2. Remove
the hinge hole covers and screws.
Move the door
catch cover to the opposite
side.
3. While supporting
the door remove
2 screws
in the hinges
that secure the hinges
to the cabinet.
4.
Remove
the door by lifting slightly
at the hinges
and pulling the hinge tabs out of the hinge slots.
5. Move the following
parts to the opposite
side of the door:
2 hinges and 4 hinge screws,
4 door
screws,
door strike and screw, inner door cover plate and screw.
6. Attach
the door to the opposite
side of the cabinet
using the 2 counter
sunk hinge screws.
(See below.)
7. Driving the lower hinge screw first wilt help to align the door and hinges.
8. Replace
the hinge hole covers
and screws
in the opposite
side.
i"
¢
;
I
" F
_'--,.
,
I
I
I
I
I
I
r_
I
I
L
III
It
l
i
illll_
llillll
_
III_III
I11
o=.=l=
"I
Publicidad
