Publicidad
Idiomas disponibles
Idiomas disponibles
iNSTALLATiON
Parts and literature
are packaged
inside of dryer drum.
To install...
R
m
R
4.
5.
Move dryer to an appropriate
location for installation.
Consider
installing
the
dryer before the washer
in side-by-side
installations,
to allow access
to gas,
electrical
and exhaust
connections.
Lay two of the carton corner
posts on the floor.
Tip the dryer forward
on its
front so it will lay across both corner
posts.
Remove
the crate wires holding the crate base to the base frame.
This can
be done with a screwdriver.
Loosen the leveling
locking nuts and install the vinyl feet.
Set the dryer
back in an upright
position.
Review the exhaust
section
on the reverse side before installing
the
exhaust
system.
Install the ductwork
from the dryer to the exhaust
hood.
The crimped end of the duct sections
must point away from the dryer.
DO NOT use sheet metal screws when assembling
ducting.
These joints
should
be taped.
Never use plastic
flexible
exhaust
material.
Tip for tight installations:
install a section
of exhaust
system
to the dryer
before
moving the dryer in place.
Use duct tape to secure this section
to
the dryer but do not cover louvers
in dryer cabinet.
!1
I
li !l
• Improper
connection
of the equipment-grounding
conductor
can result in a risk of electrical
shock.
Check with a qualified
electrician
or serviceman
if you are in doubt as to whether
the appliance
is properly
grounded.
Do not modify the plug provided
with the appliance
-
if it will not fit the outlet,
have a proper outlet installed
by a qualified
electrician.
• To prevent
unnecessary
risk of fire, electrical
shock or personal
injury, all wiring
and
grounding
must be done in accordance
with the National
Electrical
Code ANSI/NFPA,
No.
70-Latest
Revision
(for U.S.) or the Canadian
Electrical
code CSA C22.1 - Latest Revision
and local
codes and ordinances.
It is the personal
responsibility
and obligation
of the appliance
owner to provide
adequate
electrical
services
for this appliance.
• All gas installations
must be done in accordance
with the National
Fuel Gas Code ANSI/Z2231
- Latest
Revision
(for the United States)
or the CAN/CGA
- B149 Installation
Codes - Latest Revision
(for
Canada)
and local codes and ordinances.
Publicidad
