Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Always unplug power cord from
electrical outlet before performing any
service on carpet cleaner.
Empty the dirty water tank when the dirty
liquid reaches the "Max Fill" line and there
is a loss in suction. During normal use,
debris may accumulate in the dirty water
tank. In order to keep the carpet cleaner
functioning properly, rinse out the dirty
water tank with clean water after each
use.
1. Open both the dirty water tank locking
latches. Hold the dirty water tank holder
to lift up the dirty water tank from the
main body as shown.
Dirty
Water
Tank
Holder
EMPTYING THE DIRTY WATER TANK
2. Pull up the dirty water tank cover
release and open the cover.
3. Empty the tank. Drain liquids into a
suitable receptacle or drain. Rinse the
tank thoroughly with clean water when
finished cleaning. Allow the tank to air
dry before reinstalling.
DO NOT wash in the dishwasher.
DO NOT install tank while damp.
4. Close the tank cover until you hear a
'click'.
5. Before replacing the dirty water tank
back into the unit, remove any debris
from the air outlet area as shown.
- 16 -
Dirty Water
Tank Cover
Release
Air
Outlet
Publicidad
