Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Always unplug power cord from
electrical outlet before performing
maintenance to the carpet cleaner.
Replace the belt whenever a burning
rubber smell caused by excessive slippage
occurs.
1. Push the recline button; lay the carpet
cleaner on floor with the bottom up and
the floor nozzle flat.
2. Use a Phillips head screwdriver to
remove the three screws as indicated in
the illustration from the lower plate.
3. Remove the two small covers which are
secured by the screws.
4. The two brushrolls are connected
together as an assembly. Lift the
brushroll assembly up to the angle as
shown.
BELT CHANGING
5. Carefully remove the belt end cover.
6. Remove the worn or broken belt. Then
the brushroll assembly can be lifted
out from the nozzle cover. Note that
two small washers at the belt ends
of the brushrolls need to be properly
conserved. Be careful to ensure that
these do not get lost.
- 21 -
Belt
Belt End Cover
Washers
Brushrolls
Publicidad
