Publicidad
Idiomas disponibles
Idiomas disponibles
4. Dismounting the blade
CAUTION
Never touch the saw blade immediately after use.
The metal is hot and can easily burn your skin.
(1) After pivoting the blade holder, point the blade
downward. The blade should fall out on its own. If the
blade fails to fall out, pull it out by hand.
WHEN THE BLADE IS BROKEN
Even when the saw blade is broken and remains inside
the slit of the blade holder, it should fall out when
the blade holder is pivoted and the blade is pointed
downward. If the blade fails to fall out on its own, take it
out by using the procedures described below.
(1) If a part of the broken saw blade is sticking out of the
slit of the blade holder, pull out the protruding part
and take the blade out.
(2) If the broken saw blade is hidden inside the slit, hook
the broken blade using a tip of another saw blade and
take it out. (Fig. 10)
Another blade
MAINTENANCE AND INSPECTION OF SAW BLADE
MOUNT
(1) After use, blow away sawdust, earth, sand, moisture,
etc., with air or brush them away with a brush, etc., to
ensure that the blade mount can function smoothly.
NOTE
Continued use of the tool without cleaning the
area where the saw blade is attached can result in
sawdust and chip buildup which may adversely aff ect
the movement of the blade holder. Should this be the
case, pivot the blade holder and clean around the
blade holder by wiping or blowing away the buildup.
CAUTION
Do not use any saw blade with a worn-out blade
hole. Otherwise, the saw blade can come off ,
resulting in personal injury. (Fig. 11)
Blade
Slit of the blade holder
Fig. 10
Blade hole
Fig. 11
5. Adjusting the base (Fig. 12)
To maximize blade life, the base slides in or out
to allow the stroke length to be adjusted for better
effi ciency.
(1) Remove the hexagonal bar wrench from its storage
spot, and use it to loosen the 2 base stopper screws
at the bottom of the front cover.
(2) Adjust the attachment position of the base.
(3) Firmly tighten the 2 base stopper screws that were
loosened.
Base
WARNING
To avoid injury and damage, do not operate the
saw without the base in place. The blade holder
may strike against the workpiece and damage
the reciprocating mechanism.
6. Check battery insertion
WARNING
If the battery is inserted while the power switch
is in the ON position, the power tool will start
operating immediately, inviting serious accident.
CAUTION
Until the battery locks in place with a little click,
if not, it may accidentally fall out of the tool
causing injury to you or someone around you.
HOUSING THE HEXAGONAL BAR WRENCH
Hexagonal bar wrench
English
Base stopper screws
(2 locations)
Hexagonal bar wrench
Fig. 12
Insert all the way
Fig. 13
13
Publicidad
