Publicidad
Idiomas disponibles
Idiomas disponibles
English
OPERATION
WARNING
● Never touch the moving parts.
● Do not remove the front cover (refer to Fig. 2).
Be sure to hold the body from the top of the front
cover.
CAUTION
● Be careful not to let sawdust, earth, moisture,
etc., enter the inside of the machine through the
plunger section during operation. If sawdust
and the like accumulate in the plunger section,
always clean it before use.
● During use, press the base against the material
while cutting.
Vibration can damage the saw blade if the base
is not pressed fi rmly against the workpiece.
Furthermore, a tip of the saw blade can
sometimes contact the inner wall of the pipe,
damaging the saw blade.
● Select a saw blade of the most appropriate
length. Ideally, the length protruding from the
base of the saw blade after subtracting the stroke
should be larger than the material (Fig. 14).
Stroke
Stroke
Fig. 14
If you cut a large pipe, large block of wood, etc.,
that exceeds the cutting capacity of a blade;
there is a risk that the blade may contact with
the inner wall of the pipe, wood, etc., resulting in
damage. (Fig. 15)
Stroke
Stroke
14
Fig. 15
● To extend the lifetime, the lithium-ion battery
equips with the protection function to stop the
output. Therefore, if the tool is overloaded, the
motor may stop. However, this is not the trouble
but the result of protection function. In this case,
release the switch of tool and eliminate the
causes of overloading.
● Don't remove the tool from workpiece during a
cut while the saw blade is moving.
NOTE
Take care not to lock the motor. If the motor is locked,
immediately turn the power off . If the motor is locked
for a while, the motor or battery may be burnt.
1. Switch operation
(1) Lock-off button
The tool is equipped with a lock-off button. To start
the tool, press the lock-off button and then squeeze
the trigger switch. (Fig. 16)
Lock
Lock-off button
CAUTION
Do not fi x and secure the lock-off button.
Besides, keep your fi nger off the trigger switch
when the tool is being carried around. Otherwise,
the trigger switch can be inadvertently turned
ON, resulting in unexpected accidents.
Lock-off button
Push
Trigger switch
Unlock
Push
Fig. 16
Publicidad
